The BoosterPlug is an effective and cost efficient way to cure the fuelling problems on twin throttle body V7 mark 1 models.
Plugging directly into the wiring harness using original connectors, with no cutting or splicing required, installation takes less than ten minutes.

The BoosterPlug features a unique technology to provide your bike with a controlled fuel enrichment in all ambient temperature situations. No other Plug and Play device does this. A richer mixture is provided only when needed i.e at low RPMs and when accelerating. On open roads at a constant speed the Boosterplug sits idle to keep fuel consumption low.
Make your bike run as it should have done from the factory!

• Improved and gentler throttle action when opening and closing throttle
• Richer mixture when opening the throttle improves acceleration
• Removes the uneven low speed running that is typical for modern lean burn engines
• Stronger and more consistent at idle.
• Reduced backfiring with aftermarket exhausts on engine braking
• Improved fuel economy

Full seal kit and gasket set for overhauling the rear drive box

For Breva 750 up to frame no. LL11190

Bearings available separately

 3 in stock

Stylish italian made large clear screen supplied with fitting kit

Supplied ready to fit. Also available as a tinted screen by special order - please call us to order

 This part is due back in stock soon, call 01484 841395 to reserve yours

1 litre of Agip SAE 5W fork oil, lighter weight than standard on most Guzzi models. Eni Fork Oil 5W is a product designed for the motorcycle industry designed and developed for use in forks and shock absorbers, suitable for both road and off-road use.

. ENI oils were previously sold under the AGIP nameAs recommended by Guzzi. One litre will refill both forks on most models, check your manual for exact quantity required. 10W also available, use a combination of 5W and 10W to tune your damping more precisely

Please note this part CANNOT be posted outside of the UK mainland area. It is also possible to obtain intermediate grades by mixing with other Fork Oil grades.

 More than 5 in stock

The BoosterPlug is an effective and cost efficient way to cure the fuelling problems common to all modern fuel injected Guzzi's.
Plugging directly into the wiring harness using original connectors, with no cutting or splicing required, installation takes less than ten minutes.

The BoosterPlug features a unique technology to provide your bike with a controlled fuel enrichment in all ambient temperature situations. No other Plug and Play device does this. A richer mixture is provided only when needed i.e at low RPMs and when accelerating. On open roads at a constant speed the Boosterplug sits idle to keep fuel consumption low.
Make your bike run as it should have done from the factory!

• Improved and gentler throttle action when opening and closing throttle
• Richer mixture when opening the throttle improves acceleration
• Booster plug removes the uneven low speed running that is typical for modern lean burn engines
• Stronger and more consistent at idle.
• Reduced backfiring with aftermarket exhausts on engine braking
• Lifetime warranty

 1 in stock

Stylish italian made clear screen supplied with fitting kit

Supplied ready to fit. Not for V7 III Stone Nightpack. Also available as a tinted screen by special order - please call us to order

 This part is available by special order, request a quote

Full drive box seal kit and gasket set for overhauling the rear drive box

For Breva 750 from frame no. LL111908.

Bearings available separately

 2 in stock

One litre AGIP brake and clutch fluid, this is a high performance DOT 3 and 4 fluid suitable for all Moto Guzzis

Mixes safely with other DOT 3 , DOT 4 and DOT 5.1 brake and clutch fluids. If you are having problems bleeding your brakes you may need one of our one way bleed nipples BRA41651 and BRA41650

Please note this part CANNOT be posted outside of the UK mainland area.

See BRA99014 for high performance alternative

 More than 5 in stock

1 litre of Agip SAE 10W fork oil. Eni Fork Oil 10W is a product designed for the motorcycle industry designed and developed for use in forks and shock absorbers, suitable for both road and off-road use. The product is part of the Fork Oil series, which includes products with a different viscosity gradient to be selected in relation to the manufacturer's requirements and/or the damping action desired. It is also possible to obtain intermediate grades by mixing with other Fork Oil grades.

As recommended by Guzzi. One litre will refill both forks on most models, check your manual for exact quantity required. 5W also available, use a combination of 5W and 10W to tune your damping more precisely

Eni Fork Oil 10W is equipped with appropriate rheological features such as low temperature fluidity, high viscosity index and a very low sliding point, which results in smooth and uniform suspension behavior in a wide range of temperatures.

This product is characterized by high anti-wear properties, which ensure high protection and long service life to the lubricating parts.

The corrosion-resistant properties of Eni Fork Oil 10W allow effective protection of surfaces against corrosive phenomena.

Eni Fork Oil 10W has the necessary properties for the correct operation of the lubricated equipment, such as low foaming, low air retention, stability in hot conditions, and compatibility with rubber materials (gaskets).
Please note this part CANNOT be posted outside of the UK mainland area. ENI oils were previously sold under the AGIP name

 More than 5 in stock

GU30530527

Full service kit for single throttle body models containing 1 x UFI oil filter, 1 x UFI air filter, 2 x NGK CPR8EB-9 spark plugs, 2 x rocker cover gaskets and all crush washers and O rings to complete a service on your bike

Save £'s by buying everything in a service kit

The oils you need are 2 x OIA01051 1 x OIA08194 + 1 x OIA08193. Order service oil kit OIA28001 if you require oil with your service parts. See FUA01090 for fuel filter

 1 in stock